Hantek DSO5102P Digital Storage Oscilloscope 100MHz 2-Channel vs Riden RD6018 Programmable Bench Power Supply 60V 18A
Head-to-head spec comparison to help you pick the right supply for your needs.
Hantek
$189
Riden
$139
Spec-by-Spec Comparison
| Spec | Hantek DSO5102P Digital Storage Oscilloscope 100MHz 2-Channel | Riden RD6018 Programmable Bench Power Supply 60V 18A |
|---|---|---|
| Output Voltage | 0 V | 60 V |
| Max Current | 0 A | 18 A |
| Load Regulation | 0 % | 0.05 % |
| Ripple & Noise | 0 mV | 50 mV |
| Programmable | No | Yes |
| Channels | 2 | 1 |
| Display | 7-inch 800×480 TFT | Color TFT |
| Interface | USB | WiFi (Modbus) + USB |
| Price | $189 | $139 |
| Rating | 7.8/10 | 8.7/10 |
| Buy on Amazon | Buy on Amazon |
Pros & Cons
Hantek DSO5102P Digital Storage Oscilloscope 100MHz 2-Channel
Pros
- 100MHz bandwidth with 1GSa/s sample rate handles most hobby and moderate-speed digital signals
- 7-inch 800×480 TFT display — largest screen at this price point
- USB host + device ports: save screenshots to USB stick without a PC
- 25 automatic measurements (Vpp, frequency, rise time, duty cycle) without manual cursors
- Active community with custom firmware patches addressing UI quirks
Cons
- Trigger system requires careful configuration for complex serial protocols — no built-in serial decode
- Probe compensation adjustment is fiddly and not clearly documented in the manual
- Fan runs continuously at audible volume — not a quiet instrument
- Software update process requires USB boot; less polished than Rigol or Siglent equivalents
Riden RD6018 Programmable Bench Power Supply 60V 18A
Pros
- 60V / 18A (1080W) covers ham radio transceiver and amplifier power requirements at a fraction of comparable commercial supplies
- Color TFT display shows V, A, W, and input voltage simultaneously
- WiFi-enabled with open Modbus protocol; integrates into home lab automation without proprietary software
- Ripple measured at <50mV even at full load — acceptable for RF and audio applications
- Open-source firmware ecosystem; community maintains active feature branches
Cons
- Requires external 60V AC-DC transformer (not included) — total cost rises to ~$200 with a suitable Meanwell brick
- Initial firmware setup requires reading documentation — not appropriate for first-time users
- No galvanic isolation — cannot float the output for differential measurements
- At full 18A load, heat dissipation is significant; requires clearance for airflow
Our Verdicts
Hantek DSO5102P Digital Storage Oscilloscope 100MHz 2-Channel
For a first oscilloscope under $200, the DSO5102P punches above its weight on screen size and bandwidth. Engineers needing I2C/SPI/UART decode should budget up to a Rigol DS1054Z; hobbyists measuring power supply ripple and basic waveforms will find this more than sufficient.
Riden RD6018 Programmable Bench Power Supply 60V 18A
The RD6018 is the power-dense pick for engineers and ham radio operators who outgrew 30V/5A supplies. The WiFi Modbus integration is the differentiator — no other supply at this price offers open-protocol remote control. Budget ~$60 extra for a suitable AC-DC brick.